ONKYO TX-SR8370 Manual Do Utilizador
94
Troubleshooting
—Continued
The AV receiver contains a microcomputer for signal pro-
cessing and control functions. In very rare situations,
severe interference, noise from an external source, or
static electricity may cause it to lockup. In the unlikely
event that this happens, unplug the power cord from the
wall outlet, wait at least five seconds, and then plug it
back in again.
cessing and control functions. In very rare situations,
severe interference, noise from an external source, or
static electricity may cause it to lockup. In the unlikely
event that this happens, unplug the power cord from the
wall outlet, wait at least five seconds, and then plug it
back in again.
Onkyo is not responsible for damages (such as CD
rental fees) due to unsuccessful recordings caused by
the unit’s malfunction. Before you record important
data, make sure that the material will be recorded cor-
rectly.
rental fees) due to unsuccessful recordings caused by
the unit’s malfunction. Before you record important
data, make sure that the material will be recorded cor-
rectly.
To reset the AV receiver to its factory defaults, turn
it on and, while holding down the [VIDEO 1] button,
press the [STANDBY/ON] button. “Clear” will
appear on the display and the AV receiver will enter
Standby mode.
it on and, while holding down the [VIDEO 1] button,
press the [STANDBY/ON] button. “Clear” will
appear on the display and the AV receiver will enter
Standby mode.
For North American and Australian models, set the AV
receiver to Standby before disconnecting the power
cord from the wall outlet. For other models, set the AV
receiver to Standby and the POWER switch to OFF
before disconnect the power cord.
receiver to Standby before disconnecting the power
cord from the wall outlet. For other models, set the AV
receiver to Standby and the POWER switch to OFF
before disconnect the power cord.
TX-SR803_En.book Page 94 Friday, August 26, 2005 9:26 AM