ONKYO TX-SR508 Manual Do Utilizador

En

■

`

Wide:

Select if the listening angle is 40 degrees.

`

Narrow:

Select if the listening angle is 20 degrees.

With this setting, you can optimize the Theater-Dimen-
sional listening mode by specifying the angle of the 
front left and right speakers relative to the listening 
position. Ideally, the front left and right speakers should 
be equidistant from the listening position and at an 
angle close to one of the two available settings.

You can enter a preset name for each individual input 
selector for easy identification. When entered, the preset 
name will appear on the display.

■

`

- - -, Blu-ray, DVD, HD DVD, VCR, DVR, Tivo, 
CableSTB, SAT STB, PS3, Wii, Xbox, PC, TV, CD, 
TAPE, iPod:

To reset to the default, select “- - -”.

• Can not set the input selector by the same name.
• This menu cannot be used for the TUNER input selector.

If the impedance of any speaker is 4 ohms or more but less 
than 6, set the minimum speaker impedance to 4 ohms.
If you bi-amp the front speakers, you must change the 
“Speakers Type” setting.
For hookup information, see “Bi-amping the Front Speak-
ers” (

• When bi-amping is used, the AV receiver is able to drive up to 

5.1 speakers in the main room.

• Before you change these settings, turn down the volume.

■

`

4ohms:

Select if the impedance of any speaker is 4 ohms or 
more but less than 6.

`

6ohms:

Select if the impedances of all speakers are between 
6 and 16 ohms.

• (North American models) Do not support speakers with an 

impedance of less than 6 ohms.

■

`

Normal:

Select this if you’ve connected your front speakers 
normally.

`

Bi-AMP:

Select this if you’ve bi-amped your front speakers.

■

`

Front High: 

Front high speakers can be used.

`

Zone2: 

Zone2 speakers can be used.

Select “Zone2” if you’ve connected your Zone 2 speakers 
to FRONT HIGH OR ZONE 2 SPEAKERS L/R termi-
nals (

• If  the  “Speakers Type” setting is set to “Bi-AMP”, this setting 

cannot be selected.

■

`

Front High: 

Front high speakers can be used.

`

SurrBack: 

Surround back speakers can be used.

Select “Front High” if you’ve connected your Zone 2 
speakers to FRONT HIGH OR ZONE 2 SPEAKERS L/
R terminals, and the front high speakers to SURR BACK 
OR FRONT HIGH SPEAKERS L/R terminals.

• If  the  “Front High/Zone2” setting is set to “Front High”, this 

setting is set to “SurrBack”.

• If  the  “Speakers Type” setting is set to “Bi-AMP”, this setting 

cannot be selected.

Preparation
Press the input selector buttons to select an input source.

Front left speaker

Front right speaker