ONKYO TX-SR578 Manual Do Utilizador

En

■

Analog / PCM
With this setting, you can specify the listening mode to 
be used when an analog (CD, TV, LD, VHS, MD, turn-
table, radio, cassette, cable, satellite, etc.) or PCM digi-
tal (CD, DVD, etc.) audio signal is played.

■

Mono/Multiplex Source
With this setting, you can specify the listening mode to 
be used when a mono digital audio signal is played 
(DVD, etc.).

■

2ch Source
With this setting, you can specify the default listening 
mode for 2-channel (2/0) stereo sources in a digital for-
mat, such as Dolby Digital or DTS.

■

Dolby D/Dolby D +/TrueHD
With this setting, you can specify the listening mode to 
be used when a Dolby Digital or Dolby Digital Plus for-
mat digital audio signal is played (DVD, etc.). Specifies 
the default listening mode for Dolby TrueHD sources, 
such as Blu-ray or HD DVD (input via HDMI).

■

DTS/DTS-ES/DTS-HD
With this setting, you can specify the listening mode to 
be used when a DTS or DTS-HD High Resolution for-
mat digital audio signal is played (DVD, LD, CD, etc.). 
Specifies the default listening mode for DTS-HD Mas-
ter Audio sources, such as Blu-ray or HD DVD (input 
via HDMI).

■

Other Multich Source
With this setting, you can specify the default listening 
mode for multichannel PCM sources from HDMI IN 
such as DVD-Audio, and DSD multichannel sources 
such as Super Audio CD.

■

`

Off, 30 to 79

With this setting, you can limit the maximum vol-
ume.
To disable this setting, select “Off”.

■

`

Last, Min, 1 to 79 or Max

With this preference, you can specify the volume set-
ting to be used each time the AV receiver is turned 
on.
To use the same volume level that was used when the 
AV receiver was turned off, select “Last”.
The “Power On Volume” cannot be set higher than 
the “Maximum Volume” setting.

■

`

–12dB to 0dB to +12dB

With this preference, you can specify the headphone 
volume relative to the main volume. This is useful if 
there’s a volume difference between your speakers 
and your headphones.

■

On Screen Display
This preference determines whether operation details 
are displayed on-screen when an AV receiver function is 
adjusted.

`

On:

Displayed.

`

Off:

Not displayed.

Even when “On” is selected, operation details may not be 
output if the input source is connected to an HDMI IN.

■

TV Format (European, Australian and Asian 
models)
For the on-screen setup menus to display properly, you 
must specify the TV system used in your area.

`

Auto:

Select this to automatically detect the TV system 
from the video input signals.

`

NTSC:

Select this if the TV system in your area is NTSC.

`

PAL:

Select this if the TV system in your area is PAL.

■

`

English, Deutsch, Français, Español, Italiano, Ned-
erlands, Svenska, 

中文

This setting determines the language used for the on-
screen setup menus.