ONKYO TX-SR503E Manual Do Utilizador

52

You can use the AV receiver’s remote controller 
(RC-607M) to control your other components, including 
those made by other manufacturers. This chapter 
explains how to enter the necessary remote control code 
for the component that you want to control (e.g., DVD 
player, TV, or VCR).

Entering a remote control code for each REMOTE 
MODE button allows you to control your other compo-
nents with the remote controller. You’ll need to perform 
this procedure for each component that you want to con-
trol.

Notes:
• A remote control code cannot be entered for the 

[RECEIVER] button.

• There are the only codes available at the time that this 

instruction manual was printed.

• If the codes don’t work, try using other manufacture’s 

codes to see if it will help you preprogram your remote 
controller.

Look up the remote control code 
for the component in the appro-
priate category.
See the separate Remote Control 
Codes.

RC-

607M

While holding down the REMOTE 
MODE button that you want to 
set, press the [DISPLAY] button 
for 3 seconds.
The REMOTE MODE button lights up.

Within 30 seconds, use the num-
ber buttons to enter the 4-digit 
remote control code.
The REMOTE MODE button flashes 
twice.

Press the REMOTE MODE button 
again to select the remote con-
troller mode, point the remote 
controller at the component, and 
check the operation.
If the remote controller works OK, the 
code has been entered correctly. If not, 
try again or try another code.