ONKYO TX-NR708 Manual Do Utilizador

En

• When Audyssey MultEQ Room Correction and Speaker Setup is 

complete, the “Equalizer” will be set to “Audyssey” (

47). 

The Audyssey indicator will light (

• You can cancel Audyssey MultEQ Room Correction and 

Speaker Setup at any point in this procedure simply by discon-
necting the setup microphone.

• Do not connect or disconnect any speakers during 

Audyssey MultEQ Room Correction and Speaker Setup.

• If the AV receiver is muted, it will be unmuted automatically 

when Audyssey MultEQ Room Correction and Speaker Setup 
starts.

• Changes to the room after Audyssey MultEQ Room Correction 

and Speaker Setup requires you run Audyssey MultEQ Room 
Correction and Speaker Setup again, as room EQ characteristics 
may have changed.

• If your front speakers are bi-amped, you must 

select “Bi-Amp” in the “Speakers Type(Front)” 
setting (

45). For hookup information, see “Bi-

amping the Front Speakers” (

• If you change “Powered Zone2” setting, refer to 

“Setting the Powered Zone 2” for more details 
(

• If you are using a subwoofer(s), select “Yes” in the 

“Subwoofer” (

45). If not, select “No” and skip 

step 4.

If you use a powered subwoofer(s), adjust the sub-
woofer volume level to 75dB.
Test tones are played through the subwoofer. Use the 
volume control on the subwoofer.

• If your subwoofer does not have a volume control, disre-

gard the level displayed and press ENTER to proceed to 
the next step.

• If you set the subwoofer’s volume control to its maximum 

and the displayed level is lower than 75 dB, leave the sub-
woofer’s volume control at its maximum and press 
ENTER to proceed to the next step.

Audyssey MultEQ

®

 Room Correction and Speaker 

Setup starts.
Test tones are played through each speaker as 
Audyssey MultEQ Room Correction and Speaker 
Setup runs. This process takes a few minutes. Please 
refrain from talking during measurements and do 
not stand between speakers and the microphone.
Do not disconnect the speaker setup microphone 
during Audyssey MultEQ Room Correction and 
Speaker Setup, unless you want to cancel the setup.

Audyssey MultEQ performs more measurements. 
This takes a few minutes.

q/w to select an option, and then press 

The options are:

`

Save: 

Save the calculated settings and exit 
Audyssey MultEQ

 Room Correction and Speaker 

Setup

.

`

Cancel: 

Cancel Audyssey MultEQ

 Room Correction and 

Speaker Setup

.

• You can view the calculated settings for the speaker con-

figuration, speaker distances, and speaker levels by using 
e/r.

TV