ONKYO TX-NR708 Manual Do Utilizador

En

If you’ve connected your Zone 2 speakers to the AV 
receiver, as explained in “Connecting Your Zone 2 Speak-
ers Directly to the AV receiver” (

69), you must set the 

“Powered Zone2” setting to “Act” (Activated).

• Powered Zone 2 cannot be used if “Speakers Type(Front)” is 

set to “Bi-Amp” (

• This procedure can also be performed on the AV receiver by 

using SETUP, arrow buttons, and ENTER.

This section explains how to turn Zone 2 on and off, how 
to select an input source for Zone 2, and how to adjust the 
volume for Zone 2.

• When Zone 2 is turned off, the output from the ZONE 2 12V 

TRIGGER OUT goes low (0 volts).

The main menu appears onscreen.

• If the main menu doesn’t appear, make sure the appropri-

ate external input is selected on your TV.

q/w to select “Speaker Setup”, and then press 

ENTER.
The “Speaker Setup” menu appears.

q/w to select “Speaker Settings”, and then 

The “Speaker Settings” menu appears.

q/w to select “Powered Zone2”, and use e/r 

`

Not Act:

Use FRONT WIDE/ZONE 2 L/R terminals to 
connect front wide speakers (Powered Zone 2 
disabled).

`

Use FRONT WIDE/ZONE 2 L/R terminals to 
connect Zone 2 speakers (Powered Zone 2 
enabled).

The setup menu closes.

Zone 2 turns on, the ZONE 2 indicator lights.

• ZONE 2 12V TRIGGER OUT goes high (+12 V).

To select AM or FM, press TUNER input selector 
and ZONE 2 repeatedly. 
(North American models) You can also select SIR-
IUS.

To select the same source as that of the main room, 
press ZONE 2 twice. “Zone 2 Selector: Source” 
appears on the display.

ZONE 2 indicator flashes.

The zone is turned off, and the ZONE 2 indicator 
goes off.

ZONE 2 indicator