ONKYO TX-NR708 Manual Do Utilizador

En

• To control Zone 2, you must press the remote controller’s 

ZONE2 first.

• ZONE2 turns red while Zone 2 is on.

• Only analog input sources are output by the ZONE 2 LINE 

OUT and FRONT WIDE/ZONE 2 L/R terminals. Digital input 
sources are not output. If no sound is heard when an input source 
is selected, check if it’s connected to an analog input.

• You cannot select different AM or FM radio stations for your 

main room and Zone 2. The same AM/FM radio station will be 
heard in each room. For example, if you have an FM station for 
the main room, that station will also be used in Zone 2.

• When you connect Zone 2 speakers directly to the AV receiver,  

listening modes that require surround back speakers or front high 
speakers or front wide speakers (6.1/7.1), such as Dolby Digital 
EX, DTS-ES, THX Select2 Cinema, Dolby Pro Logic IIz 
Height, and Audyssey DSX™ are unavailable.

• When the input selector of Zone 2 is selected, power consump-

tion on standby mode slightly increases.

• While Zone 2 is on, 

u functions will not work.

■

■

If your Zone 2 speakers are connected to a receiver or inte-
grated amp in Zone 2, use its volume control to adjust the 
volume.

■

• To unmute, press ZONE2 followed by MUTING again.

• The ZONE 2 12V TRIGGER OUT goes high (+12 V).

To select an input source for Zone 2, press 
ZONE2, followed by INPUT SELECTOR.
To select AM or FM, press TUNER input selector 
and ZONE2 repeatedly. 
(North American models) You can also select SIR-
IUS.

q/w to adjust the volume.