ONKYO TXNR828 Manual Do Utilizador

When Zone 2 is turned on, the output from the 
ZONE 2 12V TRIGGER OUT jack goes high (+12 V 
and max. 150 mA for Zone 2). Connecting this jack to 
a 12-volt trigger input on a component in Zone 2 will 
make that component turn on or off as the AV 
receiver turns on or off the Zone 2.

■

• The Whole House Mode function shares the input source of 

main room with Multi Zone (

).

■

To control Zone 2/3, you must press ZONE on the 
remote controller first.
ZONE turns red when Zone 2 is on, and green when 
Zone 3 is on.

■

■

If your Zone 2 speakers are connected to a receiver 
or integrated amplifier in Zone 2, use its volume 
control to adjust the volume.

8ON/STANDBY

Input selector buttons

To turn on Zone 2/3 and select an input source, 
press ZONE 2 or ZONE 3 followed by an input 
selector button within 8 seconds.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on 
the AV receiver’s display.

• The Zone 2 trigger output goes high (+12 V).

To select AM or FM, press ZONE 2 or ZONE 3 
and the TUNER input selector repeatedly.

To select the same source as the main room’s, 
press ZONE 2 or ZONE 3 twice. “Zone 2 
Selector: Source” or “Zone 3 Selector: Source” 
appears on the AV receiver’s display.

8ON/STANDBY within 8 seconds.

The zone is turned off.

• The Zone 2 trigger output goes low (0 volts).

8RECEIVER

q/w

Input selector buttons

Press ZONE repeatedly, then point the remote 
controller at the AV receiver and press 
8RECEIVER.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on 
the AV receiver’s display.

• The Zone 2 trigger output goes high (+12 V).

To select an input source for Zone 2/3, press 
ZONE repeatedly, followed by an INPUT 
SELECTOR button.
To select AM or FM, press ZONE and the TUNER 
input selector repeatedly.

8RECEIVER.

The zone is turned off.

• The Zone 2 trigger output goes low (0 volts).

q/w.