ONKYO HT-R390 Manual Do Utilizador

En

.

■

`

`

You can select if you wish to display the volume level on-
screen, when it is adjusted.

■

`

1, 2, or 3

When several Onkyo components are used in the same 
room, their remote ID codes may overlap. To differentiate 
the AV receiver from the other components, you can 
change its remote ID from “1”, to “2” or “3”.

• If you do change the AV receiver’s remote ID, be sure to change 

the remote controller to the same ID (see below), otherwise, you 
won’t be able to control it with the remote controller.

■

`

10kHz/200kHz:

`

9kHz/50kHz:

Select the frequency step according to your area.

■

`

10kHz:

`

9kHz:

Select the frequency step according to your area.

For AM/FM tuning to work properly, you must specify the 
AM/FM frequency step used in your area. Note that when 
this setting is changed, all radio presets will be deleted.

■

`

`

When “Auto Standby” is set to “On”, AV receiver will 
automatically perform standby operation if there is no 
operation for 30 minutes with no audio and no video 
signal input.
“Auto Standby” will display on the display and OSD 
from 30 seconds before the Auto Standby functions.
Default setting: On (European and Asian models), Off 
(North American and Brazilian models)

• Depending on some sources, the Auto Standby function may 

activate during playback.

■

`

Auto:

Power feeding is interrupted when your iPod/iPhone 
is fully charged.

`

On:

Power feeding continues even if your iPod/iPhone is 
fully charged.

`

Off:

Your iPod/iPhone is not charged.

You can specify how the power is fed to your iPod/iPhone 
when the AV receiver is in Standby Mode.

• This setting cannot be selected when:

– the UP-A1 Dock with docked iPod/iPhone is not connected to 

the AV receiver, or

– the docked iPod/iPhone model is not supported.

• When  the  “UP-A1 ChargeMode” setting is set to “On”, or to 

“Auto” with your iPod/iPhone recharging, the SLEEP indicator 
is dimly lit in standby mode. In such conditions, the power 
consumption of the AV receiver slightly increases.

■

`

`

Turn this setting on to allow 

p

-compatible 

components connected via HDMI to be controlled by the 
AV receiver (

page 27).

Use the number buttons to enter ID 1, 2, or 3.
The remote indicator flashes twice.