ONKYO DTR-7.9 Manual Do Utilizador
119
Adjusting the Volume for Zone 2
Muting Zones
Adjusting the Tone and Balance of Zone 2
Notes:
• Only analog input sources are output by the ZONE 2
• Only analog input sources are output by the ZONE 2
PRE OUT and Zone 2 L/R speaker terminals. Digital
input sources are not output. If no sound is heard when
an input source is selected, check if it’s connected to
an analog input.
input sources are not output. If no sound is heard when
an input source is selected, check if it’s connected to
an analog input.
• While Powered Zone 2 is being used, listening modes
that need surround back speakers (i.e., Dolby Digital EX,
DTS-ES, and THX Ultra2 Cinema) are unavailable.
DTS-ES, and THX Ultra2 Cinema) are unavailable.
• While Zone 2 is on,
u functions will not work.
• You cannot select different AM or FM radio stations
for your main room and Zone 2. The same AM/FM
radio station will be heard in each room. For example,
if you have an FM station for the main room, that sta-
tion will also be used in Zone 2.
radio station will be heard in each room. For example,
if you have an FM station for the main room, that sta-
tion will also be used in Zone 2.
• Zones can also be unmuted by adjusting the volume.
• The Zone 2 level, balance, and tone functions have no
• The Zone 2 level, balance, and tone functions have no
effect on the ZONE 2 PRE OUT when the “Zone2
Out” setting is set to “Fixed” (page 117).
Out” setting is set to “Fixed” (page 117).
Remote
controller
On the remote controller, press
the [Zone 2] button, and then use
the VOL [
the [Zone 2] button, and then use
the VOL [
q]/[w] button.
AV receiver
On the AV receiver, press the
[Zone 2] button, and then use the
Zone 2 Level Up and Down [
[Zone 2] button, and then use the
Zone 2 Level Up and Down [
q]/
[
w] buttons.
Remote
controller
On the remote controller, press
the [Zone 2] button, and then
press the [Muting] button.
the [Zone 2] button, and then
press the [Muting] button.
To unmute a zone, on the remote
controller, press the [Zone 2] but-
ton, and then press the [Muting]
button again.
controller, press the [Zone 2] but-
ton, and then press the [Muting]
button again.
1
AV receiver
On the AV receiver, press the
[Zone 2] button.
[Zone 2] button.
2
Press the AV receiver’s [TONE]
button repeatedly to select
“Bass”, “Treble” or “Balance”.
button repeatedly to select
“Bass”, “Treble” or “Balance”.
3
Use the Tone Plus [ +] and Minus
[–] buttons to adjust the Bass,
Treble or Balance.
• You can boost or cut the Bass or Tre-
[–] buttons to adjust the Bass,
Treble or Balance.
• You can boost or cut the Bass or Tre-
ble from –10 dB to +10 dB in 2 dB
steps.
steps.
• You can adjust the balance from 0 in
the center to +10 dB to the right or
+10 dB to the left in 2 dB steps.
+10 dB to the left in 2 dB steps.
Zone 2
Tone
,