ONKYO HT-R538 Manual Do Utilizador

En

■

`

0 to 2 to 5

With this setting, you can specify by how much the 
front left and right channel output is attenuated in order 
to create the center channel. 
Setting a value “0” in the middle is set to hear a sound. 
Sound is spread in left and right (the outside) so that the 
set value is made big. Please adjust by liking.

■

`

Wide:

Select if the listening angle is 40 degrees.

`

Narrow:

Select if the listening angle is 20 degrees.

With this setting, you can optimize the Theater-Dimen-
sional listening mode by specifying the angle of the 
front left and right speakers relative to the listening 
position. Ideally, the front left and right speakers should 
be equidistant from the listening position and at an 
angle close to one of the two available settings.

You can enter a preset name for each individual input 
selector for easy identification. When entered, the preset 
name will appear on the display.

■

`

- - -, Blu-ray, DVD, HD DVD, VCR, DVR, Tivo, 
CableSTB, SAT STB, PS3, Wii, Xbox, PC, TV, CD, 
TAPE, iPod:

To reset to the default, select “- - -”.

• Can not set the input selector by the same name.
• This menu cannot be used for the TUNER input selector.

■

`

1, 2, or 3

When several Onkyo components are used in the same 
room, their remote ID codes may overlap. To differenti-
ate the AV receiver from the other components, you can 
change its remote ID from “1”, to “2” or “3”.

• If you do change the AV receiver’s remote ID, be sure to change 

the remote controller to the same ID (see below), otherwise, you 
won’t be able to control it with the remote controller.

For AM tuning to work properly, you must specify the 
AM frequency step used in your area. Note that when this 
setting is changed, all radio presets will be deleted.

■

`

10kHz:

Select if 10 kHz steps are used in your area.

`

:

Select if 9 kHz steps are used in your area.

■

`

Off:

HDMI audio is not output.

`

On:

HDMI audio is output.

This preference determines whether audio received at the 
HDMI IN is output by the HDMI OUT. You may want to 
turn this preference on if your TV is connected to the 
HDMI OUT and you want to listen to the audio from a 
component that’s connected to an HDMI IN, through your 
TV’s speakers. Normally, this should be set to “Off”.

Preparation
Press the input selector buttons to select an input source.

Front left 

speaker

Front right 

speaker

1

2

Use the number buttons to enter ID 1, 2, or 3.
The remote indicator flashes twice.