ONKYO HT-RC440 Manual Do Utilizador

With the Audio Adjust functions and settings, you can 
adjust the sound and listening modes as you like.

■

`

Main 

`

`

This setting determines which channel of a stereo 
multiplex source is output. Use it to select audio channels 
or languages with multiplex sources, multilingual TV 
broadcasts, and so on.

■

`

Left+Right 

`

`

This setting specifies the channel to be used for playing 
any 2-channel digital source such as Dolby Digital, or 2-
channel analog/PCM source in the Mono listening mode.

■

These settings apply to only 2-channel stereo sources.

`

`

Off 

With this setting, you can broaden the width of the front 
stereo image when using the Dolby Pro Logic II Music 
listening mode.

`

–3 to 0 to +3

With this setting, you can move the sound field forward or 
backward when using the Dolby Pro Logic II Music 
listening mode. Higher settings move the sound field 
backward. Lower settings move it forward.
If the stereo image feels too wide, or there’s too much 
surround sound, move the sound field forward to improve 
the balance. Conversely, if the stereo image feels like it’s 
in mono, or there’s not enough surround sound, move it 
backward.

`

0 to 3 to 7

With this setting, you can adjust the width of the sound 
from the center speaker when using the Dolby Pro Logic II 
Music listening mode. Normally, if you’re using a center 
speaker, the center channel sound is output from only the 
center speaker. (If you’re not using a center speaker, the 
center channel sound will be distributed to the front left 
and right speakers to create a phantom center). This setting 
controls the front left, right, and center mix, allowing you 
to adjust the weight of the center channel sound.

■

`

0 to 2 to 5

With this setting, you can specify by how much the front 
left and right channel output is attenuated in order to create 
the center channel. 
Changing the value from “0” to “5” will spread the sound 
of the center channel to left and right (outwards).

■

`

Wide:

Select if the listening angle is greater than 30 degrees.

`

Narrow:

Select if the listening angle is less than 30 degrees.

With this setting, you can optimize the Theater-
Dimensional listening mode by specifying the angle of the 
front left and right speakers relative to the listening 
position. Ideally, the front left and right speakers should be 
equidistant from the listening position and at an angle close 
to one of the two available settings.

• For best results, we recommend setting “

” to 20° and 

“Wide” to 40°.

“Setup”

Front left speaker

Front right speaker

Listening angle: 30°