ONKYO SL-107 Manual Do Utilizador

 

En-

 

8

 

• The power plug is not fully inserted.

 

➞

 

Insert the power plug fully into the power outlet.

 

• The OUTPUT LEVEL knob is set to the MIN level.

 

➞

 

Set the OUTPUT LEVEL knob properly.

• Pin connector cable(s) are disconnected at the LINE 

INPUT jacks.

 

➞

 

Connect cable(s) to the LINE INPUT jacks.

• Speaker cables are not properly connected to the 

SPEAKER LEVEL INPUT terminals.

 

➞

 

Connect the speaker cables properly.

• The speaker setting at the amplifier (or receiver) is 

incorrect.

 

➞

 

Check the settings at the amplifier (or receiver).

 

➞

 

Slightly increase the output level at the amplifier 
(or receiver) (see page 5). 

• The input signal is so small that the unit entered 

Standby mode.

 

➞

 

Turn the OUTPUT LEVEL knob until the 
Standby/On indicator light is green.

 

• Speaker cables are connected to the SPEAKER 

LEVEL INPUT terminals with reversed phase.

 

➞

 

If cables are connected with reversed phase, L and 
R low-range signals will cancel each other, dimin-
ishing the low-range sound. Connect the speaker 
cables properly.

• The sound source might not include a superbass range.

 

➞

 

Play a sound source that includes a superbass 
range.

 

• Pin connector cable is not inserted completely.

 

➞

 

Fully insert the pin connector cable.

• External leakage flux (induction noise by TV, etc.) 

occurs.

 

➞

 

Relocate the SL-107 away from the noise source 
and re-connect.

 

Type

Bass-reflex with built-in power 
amplifier

Use

For superbass-range repro-
duction

Frequency response

30–200 Hz
(at maximum crossover fre-
quency)

Crossover frequency

50–200 Hz (variable)

Maximum output power

150 W Dynamic

Input impedance

1.2 k

 

Ω

 

(for SPEAKER LEVEL INPUT 
terminals)
65 k

 

Ω

 

 (for LINE INPUT jacks)

Sensitivity  
    Speaker-Level  

1.6 V

    Line

230 mV

Speaker

20-cm woofer

Power supply

AC 220–230 V, 50/60 Hz

Power consumption

75 W

Dimensions (W 

 

×

 

 H 

 

×

 

 D) 230 

 

×

 

 435 

 

×

 

 401 mm

Weight

13.0 kg

Accessory

Pin connector cable (1 pc.)
Cork spacers (4 pcs.)
Instruction manual (this man-
ual)

Others

Auto standby

 

Specifications and appearance are subject to change 
without prior notice.

SL-107_Chi.book Page 8 Tuesday, September 30, 2003 2:43 PM