Rocketfish RF-WHTIB Manual Do Utilizador

RF-WHTIB

Using your universal wireless rear speaker
kit

Establishing communications between the sender and
receiver

To turn on the System:

Press the

(power) button on the back panel of the sender. The LED

indicator blinks to indicate that the sender is plugged in and in Standby

mode.

Press the

(power) button on the back panel of the receiver. The LED

indicator blinks to indicate that the receiver is plugged in and in Standby

mode.

The sender and receiver were pre-paired at the factory. When an active
link is established between them, the LED indicators turn solid.

Note: In case the indicators continue to blink after 30 seconds, it means there is no
active link between the sender and receiver. Try to connect the system manually
using the CONNECT button. For more information, see “Troubleshooting” on page
15.

Listening to the system

To listen to the system:

Power on the system. Make sure that there is an active link between the

sender and receiver.

Turn on your amplifier, then play the audio or video source through your

amplifier.

Blinking LED