Philips MCD2160 Manual Do Utilizador

4 Get started

Caution

•

Use of controls or adjustments or performance of

procedures other than herein may result in hazardous

radiation exposure or other unsafe operation.

Always follow the instructions in this chapter in

sequence.

If you contact Philips, you will be asked for the

model and serial number of this apparatus. The

model number and serial number are on the

back of the apparatus. Write the numbers here:

Model No. __________________________

Serial No. ___________________________

Prepare the remote control

Caution

•

Risk of explosion! Keep batteries away from heat,

sunshine or fire. Never discard batteries in fire.

•

Risk of decreased battery life! Never mix different

brands or types of batteries.

•

Risk of product damage! When the remote control is

not used for long periods, remove the batteries.

To insert the remote control battery:

Open the battery compartment.

Insert the supplied AAA batteries with

correct polarity (+/-) as indicated.

Close the battery compartment.

Set clock

In standby mode, press and hold

CLOCK SET on the remote control for

more than two seconds.

[24H] or [12H] hour format is

displayed.

Press / (or +/-) to select [24H]

or [12H] hour format, and then press

CLOCK SET.

The hour digits are displayed and begin

to blink.

Press / (or +/-) to set hour, and then

press CLOCK SET.

The minute digits are displayed and

begin to blink.

Repeat step 3 to set minute.

Note

•

If no button is pressed in 90 seconds, the system exits

clock setting mode automatically.

Tip

•

You can view clock information in Eco power mode by

pressing CLOCK SET.

Turn on

Press .

The unit switches to the last selected

source.

Switch to standby mode

Press again to switch the unit to standby

mode.

The clock (if set) is displayed on the panel.

Switch to ECO standby mode:

Press and hold for more than two seconds.

The display panel is dimmed.