Meyer Sound MPS-488HP Manual Do Utilizador
MM-10 OPERATING INSTRUCTIONS
19
SAFETY ISSUES
Pay close attention to these important electrical and safety
issues.
issues.
■
The MPS-488HP requires a grounded outlet.
■
Do not use a ground-lifting adapter or cut the AC cable
ground pin.
ground pin.
■
Keep all liquids away from the MPS-488HP to avoid haz-
ards from electrical shock.
ards from electrical shock.
■
Do not operate the unit if the power cables are frayed or
broken.
broken.
CONNECTING MM-10XP SUBWOOFERS TO
THE MPS-488HP
THE MPS-488HP
To connect MM-10XP subwoofers to the MPS-488HP:
1. Power off the MPS-488HP.
2. Connect audio sources (from a mixer or processor) to the
MPS-488HP Channel Inputs. Use balanced XLR cables.
3. Use the MPS-488HP Link switches to route Channel
Inputs to the desired Channel Outputs (see “Link
Switches” on page 16).
Switches” on page 16).
4. Connect the MM-10XP subwoofers to the MPS-488HP
Channel Outputs. Use composite cables (such as
Belden 1502) wired for both DC power and balanced
audio and outfitted with the appropriate connectors.
Belden 1502) wired for both DC power and balanced
audio and outfitted with the appropriate connectors.
■
When connecting MM-10XP subwoofers equipped with
Phoenix connectors to the MPS-488HPp power supply,
use Phoenix 5-pin male to Phoenix 5-pin female cables.
Phoenix connectors to the MPS-488HPp power supply,
use Phoenix 5-pin male to Phoenix 5-pin female cables.
TIP:
You can use two separate cables for
MM-10XP subwoofer connections: a 2-conduc-
tor cable for DC power and a 3-conductor cable for
balanced audio, both attached to a single Phoenix
connector on each cable end. This allows you to use
balanced audio, both attached to a single Phoenix
connector on each cable end. This allows you to use
Earth ground
Chassis ground