Meyer Sound MPS-488HP Manual Do Utilizador
CHAPTER 3: POWERING MM-10XP SUBWOOFERS WITH THE MPS-488HP
20
a larger gauge for the DC cable so you can achieve
longer cable runs (see “Cable Lengths and Cable
Gauges for MM-10XPs” on page 13).
longer cable runs (see “Cable Lengths and Cable
Gauges for MM-10XPs” on page 13).
■
When connecting MM-10XP subwoofers equipped with
EN3 connectors to the MPS-488HPe power supply, use
EN3 5-pin male to EN3 5-pin female cables.
EN3 connectors to the MPS-488HPe power supply, use
EN3 5-pin male to EN3 5-pin female cables.
■
To join two EN3 cables, one with an EN3 5-pin male
cable mount connector to one with an EN3 5-pin female
cable mount connector, use an EN3 5-pin female-to-
male cable coupler (PN 28.163.033.01).
cable mount connector to one with an EN3 5-pin female
cable mount connector, use an EN3 5-pin female-to-
male cable coupler (PN 28.163.033.01).
CAUTION:
Make sure MM-10XP loudspeaker
cables are wired correctly. For details on
assembling loudspeaker cables, see Appendix C,
“Phoenix and EN3 Cable Assembly.”
“Phoenix and EN3 Cable Assembly.”
5. Power on the MPS-488HP and monitor the LEDs on its
front panel to verify the connections (see “Voltage and
Load Current LEDs (1–8)” on page 15).
Load Current LEDs (1–8)” on page 15).
6. Check the LEDs on the MM-10XP rear panels and verify
they are green (ready to reproduce audio).
7. Enable output from the audio sources (from the mixer or
processor) connected to the MPS-488HP.
POWERING MM-10XP SUBWOOFERS WITH
THE ORIGINAL MPS-488
THE ORIGINAL MPS-488
The original MPS-488 was designed for use with the
MM-4XP miniature loudspeaker. While the MPS-488 can
power up to eight MM-4XPs, it can only power up to four
MM-10XPs (due to the MM-10XP’s higher power require-
ments and current draw).
MM-4XP miniature loudspeaker. While the MPS-488 can
power up to eight MM-4XPs, it can only power up to four
MM-10XPs (due to the MM-10XP’s higher power require-
ments and current draw).
Because the MPS-488 can power a maximum of four
MM-10XPs, the MM-10XPs should only be connected to
channel outputs 1, 3, 5, and 7. Do not use the even-num-
bered channel outputs.
MM-10XPs, the MM-10XPs should only be connected to
channel outputs 1, 3, 5, and 7. Do not use the even-num-
bered channel outputs.
!
MPS-488
P
Power Supply
MPS-488
E
Power Supply
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X