ONKYO CS-265DAB Manual Do Utilizador
En-
36
Reception is noisy, stereo FM reception suffers from hiss, the Auto Preset function doesn’t preset
all stations, or the FM ST indicator doesn’t light up when tuned to a stereo FM station.
all stations, or the FM ST indicator doesn’t light up when tuned to a stereo FM station.
• Check the antenna connections (see page 14).
• Change the position of the antenna (see page 14).
• Move the CD receiver away from a nearby TV or computer.
• Cars or airplanes can cause noisy interference.
• The radio signal will be weakened if it has to pass through a concrete wall before reaching the antenna.
• Switch to Mono mode and listen in mono. The FM ST indicator will go off (see page 26).
• If none of the above improves the reception, install an outdoor antenna (see page 14).
• Change the position of the antenna (see page 14).
• Move the CD receiver away from a nearby TV or computer.
• Cars or airplanes can cause noisy interference.
• The radio signal will be weakened if it has to pass through a concrete wall before reaching the antenna.
• Switch to Mono mode and listen in mono. The FM ST indicator will go off (see page 26).
• If none of the above improves the reception, install an outdoor antenna (see page 14).
Can’t adjust the frequency of the radio.
• Use the remote controller’s [
eTUNING]/[TUNINGr] buttons to change the frequency of the radio (see page 26).
RDS information doesn’t appear.
• The FM station you are tuned to doesn’t support RDS.
• The radio signal is weak. Change the position of the antenna. If the situation does not improve, install an outdoor
• The radio signal is weak. Change the position of the antenna. If the situation does not improve, install an outdoor
FM antenna (see page 14).
DAB reception is poor.
• Change the orientation and position of the supplied Indoor DAB/FM antenna to acquire good reception, and then
execute Auto Scan.
• Use the Outdoor antenna. If changing the antenna, you need to execute Auto Scan again.
No sound is heard from your turntable.
• Make sure the turntable has a built-in phono equalizer. If the turntable doesn’t have a phono equalizer built-in,
you must provide one.
The timer doesn’t work.
• Make sure the clock has been set correctly (see page 31).
• Timed operation will fail if the CD receiver is on at the specified On time, so make sure it’s set to Standby (see
• Timed operation will fail if the CD receiver is on at the specified On time, so make sure it’s set to Standby (see
• If a power failure occurs and the clock stops, the timer will be disabled. Reset the clock, and then enable Timer
as you desire.
The display indicates “- - : - -” when you press the [CLOCK CALL] button.
• A power failure has occurred, and the clock has stopped. Set the clock again (see page 31).
Tuner
External Components
Timer
Clock