IBM 21Y Manual Do Utilizador

FRU information (service only)

117

10. Using a screwdriver, gently pry the top of the bezel

away from the server.

11. Slide the main bezel down and gently pull away from

the server.

12. To reinstall the bezel:

a. Align the prongs in the main bezel with the

notches on the front of the server.

Note: It may be necessary to place the front of

the server near the edge of a flat surface
because the main bezel will extend slightly
below the server until it is pushed up into
position.

b. Slide the main bezel up.

c. Press in on the tabs on top of the bezel until they

snap into place.

13. Slide the CD-ROM and floppy disk drives back into

position and replace the screws.

Power/LED card

Before you begin:

•

•