IBM 21Y Manual Do Utilizador

FRU information (service only)

119

1Ý

Release tabs

2Ý

Card guide

To remove the card guide, do the following:

1. Power-off the server, if it is on.

2. Unplug the server.

3. Remove the left-side cover (see “Removing the side

4. Turn the server onto its right side so that the open left

side is facing up.

Note: Rotate the feet in toward the server so they do

not detach due to the weight of the server.

5. Remove the support bracket (see “Removing the sup-

6. Press the release lever in the center of the card guide

assembly to release the adapter cards.

7. Remove all adapter cards.

8. Detach cables from the system board.

9. Press down on the release tabs and tilt the top of the

assembly toward the back of the server.

10. Pull the assembly away from and out of the server.

11. Remove the fan from the assembly:

a. Gently pull the fan assembly away from the card

guide.

b. Pull the rubber extensions through the apertures.

12. Install the fan in the new assembly:

a. Align the rubber extensions in the fan assembly

with the apertures in the card guide and gently
press the fan into place.

b. Use needle-nosed pliers to pull the rubber exten-

sions through the apertures.

13. Install the assembly in the server:

a. Insert the two tabs on the bottom of the card guide

into the slots on the server.

b. Gently push the two release tabs through the

notches until they click into place.

c. Reconnect cables.

Fan assembly, 92 mm

Before you begin:

•

•