Chauvet E-190WW Manual Do Utilizador
Setup
OVATION™ E-190WW User Manual Rev. 3
-7-
Power Linking
The OVATION™ E-190WW supports power linking. You can power link up to 4 units on
120 V; up to 7 units on 208 V; or up to 8 units on 230 V.
This product comes with a Neutrik® powerCON® input power cord. This product does not
come with a power linking cable; however, a power linking cable is available as an option.
120 V; up to 7 units on 208 V; or up to 8 units on 230 V.
This product comes with a Neutrik® powerCON® input power cord. This product does not
come with a power linking cable; however, a power linking cable is available as an option.
DMX Linking
You can link the OVATION™ E-190WW to a DMX controller using a standard DMX
serial connection. If using other DMX-compatible products with the OVATION™ E-
190WW, you can control each individually with a single DMX controller.
serial connection. If using other DMX-compatible products with the OVATION™ E-
190WW, you can control each individually with a single DMX controller.
DMX Modes
The OVATION™ E-190WW uses the standard DMX data connection for the 1-, 2- and
3-channel DMX modes.
· Refer to the
3-channel DMX modes.
· Refer to the
to work in these modes.
· The
modes.
Master/Slave
Connectivity
The Master/Slave mode allows a single OVATION™ E-190WW (the “master”) to control
the actions of one or more OVATION™ E-190WW units (the “slaves”) without the need
of a DMX controller to control the slaves. Once set and connected, the slaves will
operate in unison with the master. For instructions on connecting and configuring this
product, see
the actions of one or more OVATION™ E-190WW units (the “slaves”) without the need
of a DMX controller to control the slaves. Once set and connected, the slaves will
operate in unison with the master. For instructions on connecting and configuring this
product, see
DO NOT connect a DMX controller to products operating in Slave mode. The DMX
controller signals may interfere with the signals from the master product.
controller signals may interfere with the signals from the master product.
The
configure the master and slaves.
If you are not familiar with or need more information about DMX standards,
master/slave connectivity, or the DMX cables needed to link this product to a DMX
controller, download the DMX Primer
master/slave connectivity, or the DMX cables needed to link this product to a DMX
controller, download the DMX Primer
from the CHAUVET® website: