Husqvarna WH4818 / 966638602 Manual Do Utilizador
opeRatIon
27
2
1
8062-022
Caster swivel
1.
Spacers, ½"
2.
Rear axle height adjustment
Rear axle height adjustment
Cutting Height Adjustment
The cutting height can be adjusted by the following
methods:
methods:
moving spacers between the upper side and
1.
the lower side of the caster swivel according to
Cutting Height Table.
Rear axle height adjustment according to the
Cutting Height Table.
Rear axle height adjustment according to the
2.
following instruction.
Stop engine and place drive levers and
a.
neutral locks in the lock position. Remove
spark plug wires from each side of the
engine.
Place a jack under center of rear deck.
spark plug wires from each side of the
engine.
Place a jack under center of rear deck.
b.
Raise the jack so that the axle adjustment
bolts may be removed.
With the jack, raise or lower the rear deck
bolts may be removed.
With the jack, raise or lower the rear deck
c.
to the desired position using the chart to
ensure proper height.
Reinstall the axle adjustment bolts and
ensure proper height.
Reinstall the axle adjustment bolts and
d.
tighten to 75 ft/lb. A tapered punch may be
used to help align the holes.
Using the Cutting Height Table, find the
used to help align the holes.
Using the Cutting Height Table, find the
e.
correct number of spacers to be placed
under the caster swivel.
Remove the lynch pin and washer from the
under the caster swivel.
Remove the lynch pin and washer from the
f.
top of the caster and reposition spacers to
the desired cutting height from the table on
the next page.
the desired cutting height from the table on
the next page.
8062-024
Remove spark plug wires