Husqvarna WH4818 / 966638602 用户手册

opeRatIon

27

8062-022

Caster swivel

1. 

Spacers, ½"

2. 
Rear axle height adjustment

The cutting height can be adjusted by the following 
methods:

moving spacers between the upper side and 

1. 

the lower side of the caster swivel according to 
Cutting Height Table.
Rear axle height adjustment according to the 

2. 

following instruction.

Stop engine and place drive levers and 

a. 

neutral locks in the lock position. Remove 
spark plug wires from each side of the 
engine.
Place a jack under center of rear deck. 

b. 

Raise the jack so that the axle adjustment 
bolts may be removed.
With the jack, raise or lower the rear deck 

c. 

to the desired position using the chart to 
ensure proper height.
Reinstall the axle adjustment bolts and 

d. 

tighten to 75 ft/lb. A tapered punch may be 
used to help align the holes.
Using the Cutting Height Table, find the 

e. 

correct number of spacers to be placed 
under the caster swivel.
Remove the lynch pin and washer from the 

f. 

top of the caster and reposition spacers to 
the desired cutting height from the table on 
the next page.

8062-024