Ariens 936036-2548 Manual Do Utilizador

GB - 13

Adjust on a level surface, with the tires inflated to the 
correct air pressure (see Specifications on page 18). 

1. Place mower deck in highest position.

2. With mower blades in line with discharge chute, 

measure the distance from mower blade to the 
ground on the left and right side of mower deck 
(figure 8). Distance should be 4 in. (10.2 cm).

3. Remove height adjuster link (item 8) from center lift 

lever (item 1) on each side of the unit (figure 7).

4. Loosen jam nuts on height adjuster links (item 8) 

and turn the adjuster links clockwise to raise the 
mower deck and counterclockwise to lower the 
mower deck (figure 7).

5. Tighten jam nuts on height adjuster links (item 8) 

(figure 7).

6. Install height adjuster link (item 8) on center lift 

lever (item 1) on each side of the unit (figure 7).

7.  Check that the mower deck is level.

• If mower deck is not level, repeat steps 

3 through 6.

• If mower deck is level, then adjust pitch of mower 

deck.

1. With the end of mower blades facing forward, 

measure the distance from mower blade and the 
ground at the front of mower deck. (figure 9).

NOTE: Adjust mower pitch so front end of mower blade is 
1/8 in. to 1/4 in. (3 mm to 6 mm) lower than back end of 
mower blade (figure 9).

2. Loosen pitch adjusting hardware (item 4) on each 

side of mower deck (figure 7).

3. Adjust mower deck up or down to achieve proper 

pitch.

4. Tighten pitch adjusting hardware (item 4).

Figure 7

OT1080

1. Center Lift Lever
2. Rear Hanger Bracket
3. Rear Hanger
4. Pitch Adjusting 

Hardware

5. Pin
6. Slotted Bracket
7. Front Hanger Bracket
8. Height Adjuster Link

5

3

7

2

8

1

6

4

2

1

3

1. Mower Blade
2. Mower Deck

3. Ground Level

OT1810

Figure 8

4 in. (10.2 cm)

2

1

3

1. Mower Blade
2. Mower Deck

3. Ground Level

OT1820

Figure 9

Front

1/8-1/4 in. (3 - 6 mm) lower

Figure 10

1. Mower Deck
2. Mounting Hardware
3. Antiscalp Roller

4. Pin
5. Roller Clevis

IT0860

4

5

1

2

3