Ariens 936036-2548 Manual Do Utilizador

 

GB - 9

 

Move lever to fast (1) position to increase 
engine speed. Move lever to slow (2) 
position to decrease engine speed.

 

Set throttle to approximately 

1/2 speed when engaging PTO.

 

Apply choke when starting a cold engine.

To apply choke on model 936034:

Place throttle lever in choke position.

To apply choke on other models:

Pull choke knob out. Press knob in to 
disengage choke.

 

The power take-off switch is used to engage 
and disengage the attachment. Lift switch to 
engage attachment. Push switch down to 
disengage attachment.

With key in run position, flip light switch 
forward (1) to turn headlights on. Flip light 
switch backward (2) to turn headlights off.

Fully depress brake pedal to stop unit.

IMPORTANT: DO NOT leave foot on pedal 
during operation as belt slippage may 
occur.

To raise attachment, depress thumb button 
on lift lever and raise lever to raise 
attachment.

To lower attachment, depress thumb button 
and slowly allow lever to move downward to 
lower attachment.

To engage:

Fully depress brake pedal and pull parking 
brake knob out.

To disengage:

Depress brake pedal.

Press the front end of pedal downward to 
move tractor forward.

Press the rear end of pedal downward to 
move the tractor backward.

Removing foot from pedal returns unit to 
neutral.

1. Move the handle on the seat towards the center of 

the tractor.

2. Slide seat into a comfortable position.

3. Release handle to lock seat in position.

Pull bypass lever rearward and lock in slot 
to disengage transmission (2). Pull lever 
out of slot and slowly release forward to 
engage transmission (1).

IMPORTANT: Start unit with transmission 

bypass lever in disengaged position when starting engine 
in freezing temperatures (below 32˚F/0˚C). Slowly 
engage transmission, allowing transmission to warm up 
before applying load.

Use the cruise control switch to maintain 
desired speed. Depress forward pedal to 
desired speed and push the cruise control 
switch forward to engage (1).

Flip cruise control switch back or depress 
brake pedal to disengage (2) cruise control.

NOTE: Turning off cruise control switch 

without foot on forward or reverse pedal will stop unit 
abruptly.

IMPORTANT: If the forward pedal or reverse pedal is 
repositioned while cruise indicator light is on, cruise will 
reset at the new speed and/or direction selected.

To open, push hood latch to the right, lift hood and place 
prop rod in slot under hood.

To close, remove prop rod from slot and lower it to side of 
engine. Lower the hood until it rests on the latch. Press 
down firmly at the center of the hood to snap it into latch.

The symbols on the dash will light up when key is turned 
to the run position if one of the following conditions exist:

1

2

OT0710

OT0610

OT0650

OT0620

P

OT1580

1

2

OT0630

1

2

OT0640