Ariens 932035 - 724 Manual Do Utilizador

GB - 19

Refer to Engine Manual for detailed 
instructions.

The engine crankcase oil should be checked 
every 5 hours of operation. Oil level MUST be 
maintained in safe operating range on dipstick 
at all times or engine damage will result (See 
Engine Manual).
Park unit on a level surface. Refer to Engine 
Manual for detailed instructions.

Change oil after first 2 hours of operation, 
thereafter change oil every 25 hours (more 
often if required). Refer to Engine Manual for 
detailed instructions.
Run engine just prior to changing oil. Warm oil 
will flow more freely and carry away more 
contamination.

Keep tires at pressure listed on the tire 
sidewall.

IMPORTANT: Proper oil level must be 
maintained.
Gear cases are filled to the correct level at the 
factory. Unless there is evidence of leakage, 
no additional lubricant should be required. 
Check oil level each season or every 25 hours 
of operation.
To ensure adequate lubricant level:

1. Remove filler plug (Figure 7). Lubricant 

must be at least up to bottom of lubricant 
filler hole with unit resting on a level-
surface.

2. Add lubricant if required. Allow oil to drain 

to level of plug and replace plug. 

IMPORTANT: Use only Ariens special gear 
lubricant L-2 (Part Number 00008000).

IMPORTANT: Wipe each fitting clean before 
and after lubrication.
IMPORTANT: DO NOT allow grease or oil to 
get on friction disc, friction plate or belts.
NOTE: Apply Stens Mix Hi-Temp Grease or 
equivalent to the lubrication fittings. See 
Service Parts.
Sno-Thro should be lubricated (Figure 8) at 
beginning of season or every 25 operating 
hours.

NOTE: To grease auger shaft, remove shear 
bolt nuts, and shear bolts. Turn auger on shaft 
while applying grease at zerk fittings. Replace 
shear bolt per instructions in Service and 
Adjustments.

Figure 7

1. Auger Gearcase
2. Filler Plug

OS1870

1

2