Ariens 932035 - 724 Manual Do Utilizador

GB - 21

Runners should be adjusted (Figure 11) as 
conditions require.

1. Position unit on a hard, flat, smooth level 

surface. 

2. Adjust runners by inserting a spacer of 

desired thickness under center of scraper 
blade, loosen runner hardware, slide 
runners to flat surface. Allow 1/8 in 
(3 mm) between scraper blade and hard 
smooth surfaces. Allow 1-1/4 in (30 mm) 
between scraper blade and uneven or 
gravel surfaces. Retighten hardware.

NOTE: Keep housing level by adjusting 
runners equally. 

IMPORTANT: Damage to auger/impeller 
housing will result if blade wears down too far.
Scraper blade is adjustable to compensate for 
wear.
To adjust scraper blade:

1. Tip unit back onto handlebar, support 

housing and loosen nuts retaining blade. 

2. Adjust runners to fully raised position 

(housing closest to ground). 

3. Reposition scraper blade flush with 

runners and tighten lock nuts. 

IMPORTANT: Use only Ariens shear bolts for 
replacement. Use of any other type of shear 
bolt may result in severe damage to unit.
Occasionally a foreign object may enter the 
auger/impeller housing and jam the auger, 
breaking shear bolts (Figure 12) which secure 
the auger to the shaft. This allows auger to 
turn freely on the shaft preventing damage to 
gear drive.

1. Slide auger outward against roll pin and 

align hole in shaft with hole in auger 
(holes in shaft for roll pins and shear bolts 
line up).

2. Drive shear bolt through hole (if shear bolt 

was broken this will drive remaining part 
from shaft).

3. Secure shear bolt with nut.

Figure 10

1. Pinion
2. Chute Gear
3. Carriage Bolt
4. Spring

DS0113

1

2

3

4

Figure 11

1. Runner
2. Runner Hardware

1

2

Figure 12

1. Auger
2. Shear Bolts
3. Roll Pin

1

2

3

OS0402