Ariens 932035 - 724 Manual Do Utilizador

GB - 22

To adjust (Figure 13):

1. Remove hair pin from adjustment pivot 

pin.

2. Pull shift rod and adjustment pivot pin out 

of speed selector lever.

3. Place the speed selector in the fastest 

reverse speed position.

4. Pull the shift rod straight up towards the 

control panel as far as it will go.

5. Thread the adjustment pivot pin along the 

shift rod until it aligns with the mating hole 
on the speed selector lever.

6. Turn adjustment pivot pin three turns up 

the shift rod (Figure 13).

7. Reinsert the pivot pin into the hole on the 

speed selector lever.

8. Check forward and reverse speeds.

a. Start unit.
b.  Shift speed selector into first forward 

speed.

c. Engage traction clutch. Unit should 

move forward.

d. Stop unit.
e.  Shift speed selector into first reverse 

speed.

f.  Engage traction clutch. Unit should 

move backward.

g. Shut off unit.

9. Adjust pivot pin as needed so unit travels  

forward when speed selector lever is in 
first forward position and backward when 
speed selector lever is in first reverse 
position.

10. Secure adjustment pivot pin to speed 

selector lever with hairpin.

(Figures 14 and 15)

1. Shut off engine, remove key, disconnect 

spark plug wire and allow unit to cool 
completely.

2. Remove two screws securing belt cover 

to unit and remove belt cover. 

3. Remove spring pin from chute crank rod 

assembly at universal joint and separate.

4. Remove hardware holding chute strap to 

engine mounting bracket and lift 
discharge chute off housing.

5. Remove belt finger by removing cap 

screws mounting belt finger to engine.

6. Remove attachment drive belt from 

engine sheave (it may be necessary to 
turn engine sheave using recoil starter 
handle).

IMPORTANT: To avoid bending bottom cover, 
when tipping unit apart, support handlebars 
firmly or tip unit up on housing and remove 
bottom cover by removing four cap screws 
before separating unit.

7. Support Sno-Thro frame and housing.
8. Remove top two cap screws and loosen 

lower cap screws holding blower housing 
to frame (one on each side).

9. Separate housing from unit. Lower 

handlebar on floor.

10. Remove attachment drive belt from lower 

pulley (hold brake away from belt).

Figure 13

1. Shift Rod
2. Adjustment Pivot Pin
3. Speed Selector Lever
4. Hairpin

OSs0194

1

2

3

4

CAUTION: Always support 
Sno-Thro frame and housing when 
loosening the cap screws holding 
them together. Never loosen cap 
screws while unit is in service 
position.