Jacuzzi J - 480 Manual Do Utilizador

Page 78

In the unlikely event your spa is not working the way you believe it 

should, please first review all the installation and operating instructions in 

this manual and check the message on the panel display; second, if you 

are still not satisfied it is working properly, please follow the appropriate 

troubleshooting instructions.

NONE OF THE 

COMPONENTS 

OPERATE (i.e. 

pump light)

Check the control panel lights.

1.  If there are letters or symbols displayed on 

the screen, refer to the previous section to 

determine the meaning and action required.

2.  If nothing appears on the screen:

A. Check the household circuit breaker.

B. Contact you dealer or authorized service 

center.

PUMP DOES 

NOT OPERATE 

AND ICON DOES

Activate the “JETS”:

1.  If no sound is detected or if a “buzzing” sound 

is detected, turn off power to the spa and 

contact your dealer or service center.

2.  If motor operates but no water flows to jets:

A. Pump may not be properly primed. See 

instructions below.

B. Contact dealer or authorized service center.

1.  Turn off power to the spa.

2.  Remove the handle from the massage selector supplied by the pump 

you are priming.

3.  Loosen the massage selector’s cap slightly (counterclockwise), 

listening for the air to seep out.

4.  Tighten the cap finger-tight, replace the handle and turn the hot tub’s 

power back on.

note: This method must be used for the jet’s pumps because these 

pumps are not connected to the main filter system in any way.

CauTIOn: If freezing conditions exist and pump is not operational, 

take measures to protect the system from freeze damage. See 

Section titled “Winterizing” (page 70).