Jacuzzi J - 400 Manual Do Utilizador
Page 78
J-400 Series
1. Make certain the jets pump is turned on.
2. Check position of massage selectors.
3. Open air control for selected jet system.
4. Check for adequate water level.
5. Check for dirty filter (page 67).
2. Check position of massage selectors.
3. Open air control for selected jet system.
4. Check for adequate water level.
5. Check for dirty filter (page 67).
WATER IS TOO HOT
1. Reduce thermostat setting (page 18).
2. Switch hot tub to “Programmable” mode
2. Switch hot tub to “Programmable” mode
to turn heater on only during programmed
filter cycles (page 60).
filter cycles (page 60).
NO HEAT
1. Check thermostat setting.
2. Keep the cover in place while heating.
3. If heater indicator is displayed, but no
2. Keep the cover in place while heating.
3. If heater indicator is displayed, but no
temperature increase is experienced after
a reasonable period of time, contact your
dealer or authorized service center.
a reasonable period of time, contact your
dealer or authorized service center.
FILTER/CIRCULATION
PUMP OFF
PUMP OFF
1. Verify filter/circulation pump is
programmed to run 12 hours a day (page
64).
64).
2. Filter/circulation pump cycle canceled by
power interruption. Wait 24 hours for hot
tub to reset.
tub to reset.
3. Hot tub water is warmer than 95°F (34°C)
and two degrees warmer than the set
temperature. The “Summer Logic” safety
feature has activated. See note on page
64 for details.
temperature. The “Summer Logic” safety
feature has activated. See note on page
64 for details.
Jacuzzi builds the best spas in the industry. Nonetheless, we are always
striving to improve the quality and features of our products. Your input
as a Jacuzzi spa owner is a cherished part of this process. If you have
any comments or suggestions, or if you wish to be informed on any new
products for your spa, please write to us.
products for your spa, please write to us.
COnGraTulaTIOns on your good taste and welcome to the happiest
and most relaxed family in the world!