Jacuzzi J - 210 Manual Do Utilizador

For best results, read each step in its entirety before proceeding with that 
step.

1.  prepare The spa For Filling

Clear all debris from the spa. (Although the spa shell has been 

• 

polished at the factory, you may want to treat it with a specially 

formulated spa cleaner.) Consult your authorized Jacuzzi dealer for 

additional information prior to filling spa.

Remove filter cover, then remove filter cartridge as outlined in section 

• 

2.  Fill spa

Place the end of your garden hose into the empty filter bucket.

• 

CauTIon:  To DeCrease BuIlD up on ComponenTs anD 

mInImIZe aCrYlIC DamaGe. 
Never fill with water from a water softener. If your water is extremely 
“hard”, it is preferable to fill half-way with hard water and the rest of 
the way with softened water. You may fill entirely with hard water if 
you use a special water additive available from your Jacuzzi dealer.

!

• 

 

Fill hot tub with clean tap water from garden hose, to reduce risk of 
contracting a waterborne illness (e.g. an infection, bacteria or virus) 
and/or respiratory ailments. Fill until water covers all jets but does not 

touch the bottom of the lowest headrest. (DO NOT OVERFILL!)

3.   Turn on power
Turn on power to spa at the home’s circuit breaker to start boot 
up sequence (sec. 10.0, page 25). The heater and filter pump will 
automatically activate after several seconds. If the control panel LED 
flashes water temperature and “COL” or “ICE” this is normal, refer to 
page 39 for additional information.

4.   activate Jets pumps
Turn on jets pump(s) to ensure proper mixing when 
adding start-up chemicals in step 5.

5.   add start-up Chemicals

Add the spa water chemicals as recommended by your authorized 

Jacuzzi dealer. See section 13.0 “Water Quality Maintenance” (page 37) 
for general guidance.

2

1