Nilfisk Alto 5 SB FA Manual Do Utilizador

7

1)

 Options / model variants

NEPTUNE 5 SB FA 

With the machine cold, turned 
off and disconnected from power 
supply:

1.  Fill fuel tank from a clean con-

tainer with a fresh fuel (fuel oil 
EL, or Diesel oil DIN 51 603), 
or fuel type recommended by 
your distributor.

The fuel must be free from con-
tamination. 

Tank capacity see chapter 9.4 
Technical data.

months it is recommended that 
a fuel conditioner/stabilizer be 
added (available from the fuel 
oil trade).

1.  Connect the high pressure 

hose quick connector to the 
high pressure nipple (A) lo-
cated at the hose reel axle.

2.  Place the high pressure hose 

into the hose guide (B) and 
ritain it with the clip.

3.  Release the brake (C) on the 

hose reel and wind up the 
high pressure hose.      

1.  Connect the high pressure 

hose quick connector to the 
high pressure nipple located 
at right rear of machine above 
chemical tank.

1.  Attach quick connect adapter 

found with Owners Manual to  
the water supply hose.

2.  Rinse the water supply hose 

briefl y in order to prevent sand 
an other dirt particles entering 
into the machine.

3.  Attach water supply hose with 

adapter to inlet quick connec-
tor.

4.  Open water supply faucet.

NOTE!
At temperatures below 8°C 
(46°F), the fuel oil begins to so-
lidify (paraffi n precipitation). This 
can lead to diffi culties in starting 
the burner. Before the winter 

NOTE!
See chapter 9.4 Technical Data 
for required quantity of water and 
water pressure. 
In the case of poor water quality 
(sand, etc.), it is recommended 
that an inlet water fi lter be in-
stalled.

Water supply hose should be 
a reinforced hose and have a 
minimum inside diameter of  3/4" 
(19 mm).