Casablanca Fan Company K4BR Folheto

4.  While holding light fixture up to the fan,
attach the wires from the fan switch housing
and the wires from the light fixture together
(black-to-black or blue-to-black and white-to-
white) by twisting the bare ends of the wires
together. Then secure the splices by thread-
ing on the wire nuts provided.  Test the se-
cureness of each splice by pulling on the wire
nut.  See FIG. 3
5.

5.    Attach the light fixture to the fan switch
housing using the two brass 8-32 screws,
insuring guide pins are properly located into
fan switch housing.
Caution:  Make sure no wires are pinched
between light fixture and switch housing.
Tighten the screws to secure light fixture.
6.

6.  Install glass if applicable. (not included
except for KG4T). Loosen the thumbscrews
on each shadeholder align glass inside
shadeholder as far as it will go and tighten
thumbscrews equally around the glass. Make
sure glass is snug and locked down tight so
that the glass will not rattle when the fan is in
operation.
7

7.  Install the light bulbs.  Do not exceed
the maximum wattage indicated on
the light fixture.
8.

8. Connect fob chain to light pull chain.
9.

9. Installing glass on KG4T:

a. Remove socket locking ring from the
socket. Set aside.
b. Install glass shade by aligning the
longer edge of the glass at the top
and installing socket locking ring onto
socket. Turn until glass is snug against
the shadeholder and socket locking
ring is tight.

10. Installing glass on K4BR:
(Do this step before installing on fan)

a. Install rings onto end of bullet shade

by first removing the screws, align rings with
holes in shade and re-install screws.
b. Tighten srews with a screwdriver until snug.
c. Return to Step 1.