Casablanca Fan Company 6643Z Manual Do Utilizador

14

WALL CONTROL AND HARDWARE (not to scale)

Switch Mounting

Screws (2)

Wall Plate 

Screws

(2) White

(2) Almond

White Wall 

Plate(1)

W-85

Wall Control

Switch Bezels

(1) White

(1) Almond

Almond Wall 

Plate(1)

(4) Wire Cap

Before installing the W-85 wall control you will need 

to  check and see if you will need to change the 

bezel on the front of the wall control from WHITE to 

ALMOND. If you are going to use white, skip these 

steps and go to wall control installation starting on 

page 15. The bezel can be changed at any time 

before or after installation. The wall control does 

not need to be uninstalled to replace the bezel.

Step 17a� Locate  the four (4) tabs holding the bezel to 

the front of the switch, then press in on each tab one 

at a time, removing the bezel as shown in Figure #1.

 

Step  17b�  Locate  the  rubber  key  pad  attached  to 

the four (4) locating pins as shown in Figure #2 and 

remove rubber key pad from the WHITE bezel, also 

as shown in Figure #2. 

To avoid possible electrical shock, make cer-

tain that electricity is turned off at the circuit 

breaker or fuse box before attempting any in-

stallation or repair procedure

CAUTION! NOT turning the power OFF at the 

circuit breaker or fuse box may cause damage to 

the electronics within the wall control and or the PC 

board on the fan. 

WHITE

BEZEL

RUBBER KEY

PAD

LOCATING

PINS (4)

LOCATING

PINS 

HOLES(4)

Figure #1

BEZEL

BEZEL

TABS