Casablanca Fan Company 6643Z Manual Do Utilizador

16

1. Use only the Casablanca W-85 wall control.

2. Do not use any additional control with your Inteli-

Touch 3 fan (for example, dimmer, or fan speed 

control).

3. Do not use more than one fan per wall control.
4. No other light fixtures or electrical appliances 

may be connected on the circuit controlled by the 

W-85 wall control.

W-85 is used to describe either white (-11) or almond finish. 

If you have multiple Inteli-Touch 3 fans, refer to the section 

"Changing  Frequency Setting" on page 18.

1. Remove the screws and switch plate from the existing 

switch box.

2. Remove the screws holding the switch in the switch 

box.

3. Pull the existing switch from the switch box to expose 

the wire connections.

4. Remove the two wires from the switch.

5. Connect the BLACK wire from the POWER SOURCE 

that you just removed from the switch to the BLACK/

The wall control installs in the same manner as an ordinary light switch, using an existing wall box and wiring. This 

controller is designed to signal the fan microcomputer as well as perform normal switching operations. For this 

reason the following precautions must be observed:

Ensure power is turned OFF at the breaker or fuse panel before starting installation.

Note: The RED wire is not used in this ap-

plication, DO NOT remove the crimped cap 

from the wire..

Note: W-85 Wall Control should only be installed on Casablanca's Inteli-Touch

®

 3 fans with DOWNLIGHTS 

ONLY.

WHITE STRIP wire on the W-85 wall con-

trol. Secure this connection with a wire nut.

6. Connect the second BLACK wire that you 

just removed from the switch to the second 

BLACK wire on the located on the back of 

the W-85 wall control. Secure this connec-

tion with a wire nut.

7. Connect the green ground wire coming 

from the back of the W-85 control to the 

ground wire in the switch box. Secure the 

splice with a wire nut.

8. Check your work by using the wiring dia-

grams as shown in Figures # 1 and #2.

9. Install the W-85 in the wall box with the 

two long screws provided.

10. Install the wall plate with the two color-

matched screws.

SINGLe w-85 INSTaLLaTIoN