Casablanca Fan Company 6643Z Manual Do Utilizador

19

CHaNGING freqUeNCY SeTTING

You will only have to change the dip switch settings in the remote if you 

are using more than one fan in the same area and want to control them 

separately. 

aUToMaTIC DeMoNSTraTIoN ProGraM

A multi-tone signal will verify the start of the test pro-

gram which proceeds as follows:

•  Lights slowly increase to full intensity.

•  Fan accelerates to speed three with audio tones.

•  Light dims to half intensity.

•  Fan accelerates to full speed with audio tones.

•  Fan reverses at full speed with audio tones.

•  Fan operates at full speed.

•  Fan turns off with audio tones (blades coast for a 

short time).

•  Lights turn off.

The complete cycle lasts slightly over one minute. It 

will continue to repeat until the 

 is turned off 

for more than five seconds, cancelling the program.

Programmed into every Inteli-Touch

®

 3 Series fan is 

an Automatic Demonstration Program. It can be used 

to fully demonstrate and test the operation of the fan.

1. Turn 

 off for at least 5 seconds. This will 

clear the fan memory ready for programming.

2. Turn 

 on.

3. Immediately operate the buttons in the following 

sequence:

NOTE: DO NOT set dip switch setting in the remote 

to ‘0000’, this may cause frequency interference 

from other Casablanca Products. 

Step 1. Turn power OFF at the circuit breaker or fuse box and at the toggle 

switch, for the fan you want to change. 

Step 2. Remove the screws and switch plate from the existing switch box.

Step 3. Remove the screws holding the switch in the switch box.

Step 4. Pull the existing W-85 switch from the switch box to expose the dip 

switches located on the side of the control as shown in Figure #1.

Step 5. Change the dip switch settings, assuring that they are different from 

the previously installed  Inteli-Touch

®

 3 fan.

Step 6. Mount the W-85 Wall Control unit back into the wall electrical box.

Step 7. At the circuit breaker or fuse box and at the toggle switch, turn the 

power off for the fan whose frequency you are changing.

Step  8.  Within  20  seconds  of  restoring  power  to  the  ceiling  fan  and  the 

W-85 Wall Control press and hold both the “FAN” and “REVERSE” buttons 

as shown in Figure #2 for 3 seconds, you will hear one tone from the Piezo 

Buzzer indicating the command has been accepted.