Casablanca Fan Company 6643Z Manual Do Utilizador

18

oPeraTIoN Power

The 

 button is normally left in the on position. Always turn the power off 

during cleaning or servicing the fan and during thunderstorms. It is also used to 

exit or enter additional programs.

The 

 button must be left on to retain a previously set fan speed or light level.

oPeraTIoN SPeeD CoNTroL

FAN CONTROL

ON - OFF:

A momentary 

press of the FAN 

button

CHANGE SPEED:

Press and hold 

FAN button longer 

than one second

There are six individual speed settings for the fan; each speed is indicated 

by an audible tone of increasing pitch.

To select the desired fan speed:

1. With fan off, press and hold the button labeled 

� The fan blades 

will start rotating at the slowest speed, and will increase in steps.

2. Release the button when the desired speed is reached.

The fan speed is now in memory and will automatically come on at the 

same speed each time the 

 button is used. To maintain this level 

of speed, turn the fan on by pressing 

 less than one second. To 

lower speed, turn fan off, then on by pressing and holding the 

button until the desired speed is reached. When the fan is on, you may 

increase the speed by pressing and holding the 

 button until the 

desired speed is reached, then release it.

oPeraTIoN reVerSING aIrfLow

The direction of airflow can be changed from down-

ward to upward or from upward to downward.

To reverse the airflow:

1. Make sure the 

 is on and blades are Turn-

ing.

2. Press the 

 button.

Note:  A  four-toned  signal 

indicates  the  command  was 

accepted  by  the  fan. A  few 

seconds later the fan will slow 

to  a  stop  and  then  reverse 

direction.

LIGHT CONTROL

A momentary press of 

the 

lIGhT button

To turn the lights off and on, press and release the 

 button for less than 

one second.

1) First press/release of the 

 button- The light will turn ON.

2) Second press/release of the 

 button- The light will turn OFF.

To vary the light brightness at each touch level:

1. With lights off, press and hold the  button. After one second the lights will 

come on at their lowest level and gradually become brighter. 

oPeraTIoN LIGHTS

Note: Light Operation - the light varies from “bright” to “dim” over 

approximately 8 seconds. This sequence will reverse the light when it 

reaches the brightest or dimmest level if you continue to hold the LIGHT 

button. Release the button when the desired level is reached.

2. Release the button when the desired brightness level is reached. 

The brightness level is now in the fan memory and will automatically come on at 

the same brightness the next time the  button is used.