Casablanca Fan Company C16G73T Manual Do Utilizador

The wall control installs in the same manner as an ordinary light switch, using an existing wall box and wiring. This controller 
is designed to signal the fan microcomputer as well as perform normal switching operations. For this reason the following 
precautions must be observed: 

W-32 is used to describe either white (-11) or ivory fi nish. 

1.  Remove the screws and switch plate from the existing switch box.

2.  Remove the screws holding the switch in the switch box.

3.  Pull the existing switch from the switch box to expose the wire 

connections. 

4.  Remove the two wires from the switch. 

5.  Connect the two wires just removed from the switch to the W-32 wall control 

black wire and black/white stripe wire. Secure these connections with wire 
nuts. 

6.  Connect the green ground wire coming from the back of the W-32 control 

to the ground wire in the switch box. Secure the splice with wire nut. 

7.  Install the W-32 in the wall box with the two long screws provided.

8.  Install the wall plate with the two color matched screws. 

1.  Use only the Casablanca W-32 wall control.

2.  Do not use any additional control with your Inteli-Touch fan 

(for example, dimmer, fan speed control, etc.).

3.  Do not use more than one fan per wall control. 

4.  No other light fi xtures or electrical appliances may be 

connected on the circuit controlled by the W-32 wall 
control.

CAUTION!

Ensure power is turned OFF at the breaker or fuse panel before starting installation.

NOTE:  If  wall  control  operation  is  reversed  (fan  switch  controls  lights  and 
light switch controls fan) turnoff the power at the breaker or fuse panel, then 
swap the two W-32 black/white stripe wires.

To control the fan and lights from two locations (a three-way circuit), use 2 
W-32 wall controls.

1.  Remove the screws and switch plate from the existing switch box and the 

screws holding the switch in the switch box.

2.  Pull the existing switch from the switch box to expose the wire 

connections.

3   Determine which wire is connected to the common terminal of the 3-way 

switch. (The terminal will be marked on switch).

4.  Remove the wire from the common terminal of the 3-way switch. Connect 

this wire to the remaining black/white striped wire on the W-32 control. 
Secure this splice with a wire nut.

5.  Remove the two remaining wires from the 3-way switch. Connect one of 

these wires to a black wire on the W-32 control. Secure the splice with a 
wire nut. The remaining wire is to be connected to the other black wire on 
the W-32.Secure the splice with a wire nut.

6.  Connect the green ground wire coming from the back of the W-32 control 

to the ground wire in the switch box. Secure the splice with a wire nut.

7.  Install the W-32 in the wall box with the two long screws provided.

8.  Install the wall plate with the two short color-matched screws provided.

9.  Installation of the second W-32 control is identical. Repeat steps 1 through 7.

NOTE:  If  wall  control  operation  is  reversed  (fan  switch  controls  lights  and 
light switch controls fan) turn off the power at the breaker or fuse panel, then 
swap the two W-32 black/white stripe wires. 

CAUTION!

Ensure power is turned OFF at the breaker or fuse panel before starting installation.