Casablanca Fan Company C16G73T Manual Do Utilizador

After turning the power OFF at its source (either the circuit 
breaker or fuse box), lower the old fi xture and disconnect the 
wiring. The Candelier is not to be supported by the ceiling 
box. It must be directly mounted to the support structure 
over  an  approved  electrical  outlet  box.  Please  consult  a 
licensed electrician to confi rm the right support structure 
is being used.

If you do not have an existing fi xture located where you 
wish  to  place  your  Casablanca  Candelier,  an  approved 
ceiling fi xture outlet box must be installed and wired. 

NOTE: The weight of this fan is approximately 150 pounds.

WARNING: 

The Candelier must be mounted directly to a 
structural  member  of  the  ceiling.  It  cannot  be 
mounted directly to the outlet box. 

Step 1a. Hold the crossbar hanging bracket up to the ceiling. 
Use a pen or pencil to mark screw placement through the two 
holes in the bracket. With a 9/32 inch drill bit, drill two holes 
angled outward (away from the fi xture) at approximately a 
four-degree angle.

Step 1b. Insert lag screws into the hanging bracket holes at a 
four-degree angle. Tighten bolts until they are secure against 
the ceiling. 

CAUTION: 

To reduce the risk of personal injury, use only the 
mounting hardware provided with the approved 
outlet box to install the crossbar mounting 
bracket.

CEILING HARDWARE (not to scale)

NOTE: If you have removed an old fan fi xture, check the outlet 
box to ensure that a joist or beam supports it across the upper 
surface. If not, a 2 x 4 stud must be installed. 

PARTS NEEDED FOR THIS SECTION: