Casablanca Fan Company C30G45L Manual Do Utilizador

1.  To control the fan and lights from two 

locations (a three-way circuit), use two W-74 

wall controls.

2.  remove the screws and switch plate from the 

existing switch box and the screws holding 

the switch in the switch box. Figure #5

3.  Pull the existing switch from the switch box to 

expose the wire connections.

4.  Determine which wire is connected to the 

common terminal from the power source 

(120V aC) of the three-way switch. (The 

terminal will be marked on switch).

5.  remove the wire from the common terminal 

of the three-way switch. Connect this wire to 

the remaining black/white striped wire on the 

W-74 control. Secure this splice with a wire 

nut. Figure 4

Ensure power is turned OFF at the breaker or fuse panel before starting installation.

To control the fan and lights from two locations (a three-way 
circuit), use two W-74 wall controls as shown in the wiring diagram 
in Figure #4. Before installing the two switches into the wall, place 
both switches side by side, then locate the 6 dip switches on the 
side of the two switches as shown in Figure #3. Then make sure that 
the dip switches  are set to the same address on both switches as 
shown in Figure #3. When setting these dip switches you are setting 
the channel number that is required to control both your fan and 
lights from both sides of the room. if you are installing other Direct-
Touch

TM

 3 fans within your home you may need to reset the dip 

switches on these other fans to a different channel before installing 
your W-74 wall control into the wall. Please review the section on 
channel changing within this part of the operation manual as shown 
on page #22.

DiP SWiTCHES

NOTE: The RED wire is not used in this application . 

DO NOT remove the crimped cap from the wire .

W-74
Wall Control

rED WirE
nOT USED

Connect the green ground wire coming 

from the back of the W-74 control to the 
ground wire in the switch box. Secure 
the splice with a wire nut.

Check your work by using the wiring 

diagrams as shown in Figures # 1 and #2.

install the W-74 in the wall box with the 

two long screws provided.

install the wall plate with the two white 

screws.

BLaCK anD WHiTE
STriPED WirE

2 BLaCK
WirES