Casablanca Fan Company C30G45L Manual Do Utilizador

W-74
Wall Control

BLaCK anD WHiTE
STriPED WirE

2 BLaCK
WirES

6.  remove the two remaining wires from the three-way 

switch. Connect one black wire of these wires to the black 

wire on the W-74 control. Secure the splice with a wire nut.

7.   The remaining wire is to be connected to the red wire on 

the W-74. Secure the splice with a wire nut. note: Cut and 

strip the red wire to remove the crimped connector.

8.  Connect the green ground wire coming from the back of 

the W-74 control to the ground wire in the switch box. 

Secure the splice with a wire nut.

9.  Check your work by using the wiring diagrams as shown in 

Figures # 4 and #5 on this page. 

10.  install the W-74 in the wall box with the two long screws 

provided.

11.  install the wall plate with the two short color-matched 

screws provided.

12.  installation of the second W-74 control is identical. repeat 

steps 1 through 7.

The 

 power button is normally left in the on position. always turn the 

power off during cleaning or servicing the fan and during thunderstorms. it is 
also used to exit or enter additional programs.
The 

 power button must be left on to retain a previously set fan speed or 

light level.

There are five individual speed settings for the fan. Each speed is 
indicated by the number on the controller and an audible tone for 
each speed.

To select the desired fan speed:
Press the number on the controller corresponding to the speed 
desired. 4 is high, 3 medium, 2 low, 1 ultra-low, and 0 is off.

The direction of airflow can be changed from downward to upward 
or from upward to downward.

To reverse the airflow:
1.  Make sure the fan is on and blades are turning.
2.  Press the 

 reverse button. You will hear a series of clicks from 

the fan as it speeds up before coming to a stop and changing 
direction. 

Note: It is normal for the fan to start 

in the "High" position from "Off" 

before  changing  to  the  selected 

speed .