Ryobi RYI2000T Manual Do Utilizador

10 — English

See Figure 1.
The safe use of this product requires an understanding of the 
information on the product and in this operator’s manual as 
well as a knowledge of the project you are attempting. Before 
use of this product, familiarize yourself with all  operating 
features and safety rules.

Your generator has two single phase, 60 Hz outlets that  are 
120 Volt AC, 15 Amp receptacles. These can be used for 
operating appropriate appliances, electrical lighting, tools, 
and motor loads.

The air filter help to limit the amount of dirt and dust drawn 
into the unit during operation.

The auto idle switch is used to control the speed of the 
engine and conserve fuel. When the switch is in the 

ON (I) 

position and no appliances are connected to the unit, the 
engine will idle. If an appliance is added, the engine speed 
will increase to power the item. If the appliance is removed, 
the engine will return to idle.

The battery charging cable makes it easy to charge 12 Volt 
lead acid batteries with the generator.
NOTE: Only use battery charging cable to charge vented 
wet lead acid batteries.

The generator has a carry handle for easy transport.

The choke lever is used when starting the engine.

The circuit breaker is provided to protect the generator 
against electrical overload.

Your generator has a 12 V, 7.5 amp DC receptacle for 
charging music players, cell phones, lead acid batteries, 
and 12 V appliances.

The 12 V DC receptacle is designed to charge vented 
wet lead acid batteries only. Other types of batteries may 
burst, causing personal injury and damage.

The on/off switch is used in combination with the starter 
grip and rope to start the generator. It is also used to turn 
the generator off.

The fuel tank has a capacity of 1.0 gallon.
NOTE:  The fuel flows from the fuel tank to the carburetor 
only when the on/off switch is in the 

ON (I) position.

The ground terminal is used to assist in properly ground-
ing the generator to help protect against electrical shock. 
Consult with a local electrician for grounding requirements 
in your area.

LEDs provide feedback to indicate whether the generator is 
in use, overloaded, or in need of lubricant.

Remove the oil fill cap to check and add lubricant to the 
generator when necessary.

The generator is equipped with a retractable handle that can 
be adjusted for storage and transportation.

The starter grip and rope is used (along with the on/off switch) 
to start the generator’s engine.

The generator has a fuel cap with a vent that can be opened 
and closed. During normal operation the vent should be in 
the open position.