Yamaha 01V Manual Do Utilizador
Troubleshooting
253
01V—Owner’s Manual
Troubleshooting
Symptom
Advice
Cannot turn on the 01V.
Make sure that the power cord is connected to a suitable AC wall out-
let. See “Connecting the Power Cord” on page 11 for more informa-
tion.
let. See “Connecting the Power Cord” on page 11 for more informa-
tion.
If you still cannot turn on the 01V, contact your Yamaha dealer.
The display is difficult to read.
Connected a condenser-type
microphone but it doesn’t work.
microphone but it doesn’t work.
Make sure that the +48 V phantom power is turned on for that input.
If a phone plug is plugged into the same input channel, the XLR input
is disabled. See “Input Channel Overview” on page 40 for more infor-
mation.
is disabled. See “Input Channel Overview” on page 40 for more infor-
mation.
The SELECTED CHANNEL PAN and
EQ F and G controls adjust the
wrong channel.
EQ F and G controls adjust the
wrong channel.
Input channel signal levels are too
low or too high.
low or too high.
Make sure that the GAIN control and PAD switch are set correctly. See
Gain and Pad on page 41.
Gain and Pad on page 41.
Faders don’t function as expected.
[SEL] buttons don’t function as
expected.
expected.
[SOLO] buttons don’t function as
expected.
expected.
[ON] buttons don’t function as
expected.
expected.
Effects Return Rotary controls don’t
function as expected
function as expected
Cannot access input channels 17
through 24.
through 24.
Input channels 17 through 24 are available only when an optional
Option I/O card is installed. See “About Option I/O Cards” on page
216 for more information.
Option I/O card is installed. See “About Option I/O Cards” on page
216 for more information.
Cannot select the HI-MID and
LO-MID EQ bands on input channels
17 through 24.
LO-MID EQ bands on input channels
17 through 24.
Input channels 17 through 24 feature 2-band EQ, so these bands can-
not be selected.
not be selected.
Cannot send signals from input
channels 17 through 24 to aux
sends 3 and 4.
channels 17 through 24 to aux
sends 3 and 4.
This is correct. Input channels 17 through 24 can only be sent to aux
sends 1 and 2. See “About the Aux Sends” on page 94 for more infor-
mation.
sends 1 and 2. See “About the Aux Sends” on page 94 for more infor-
mation.
Input signals 1 through 8 appear on
input channels 17 through 24.
input channels 17 through 24.
Input signals are present but the
stereo output is dead.
stereo output is dead.
Raise the STEREO fader and turn on the STEREO [ON] button. Make
sure that the input channels are routed to the stereo output. See
“Routing Input Channels” on page 49 for more information.
sure that the input channels are routed to the stereo output. See
“Routing Input Channels” on page 49 for more information.