Yamaha 02R Manual Do Utilizador
42
MIXING Display Functions
Digital Recording Console 02R User’s Guide
The third screen shows the output and auxiliary buses and the stereo
output, plus level faders for the buses:
output, plus level faders for the buses:
Select this screen by pressing the [SEL] button for the stereo output. You
can also select this screen by pressing the [METER] button until it appears
in sequence.
can also select this screen by pressing the [METER] button until it appears
in sequence.
Peak Hold
The Peak Hold function can be turned on and off from any screen of the
METER display function. Clear the peak hold levels by turning the Peak
Hold off (select the PEAK HOLD icon and press the [ENTER] button) or by
selecting another display function. The dedicated control room output
meter peak hold is not affected when other display functions are selected.
METER display function. Clear the peak hold levels by turning the Peak
Hold off (select the PEAK HOLD icon and press the [ENTER] button) or by
selecting another display function. The dedicated control room output
meter peak hold is not affected when other display functions are selected.
Meter Source Points
The following table lists the meter signal source points:
Note:
When the 02R reaches CLIP, digital signal distortion occurs. You must
ensure this does not happen. Digital distortion is very unpleasant sounding. There
are a several things you can do. If CLIP is reached, but the corresponding PEAK
indicator is not illuminated, you need to attenuate the channel slightly with the
are a several things you can do. If CLIP is reached, but the corresponding PEAK
indicator is not illuminated, you need to attenuate the channel slightly with the
∅
Guide). Otherwise, back off the GAIN control a little (see “GAIN Controls” on
page 27 of the User’s Guide).
page 27 of the User’s Guide).
Signal
Source Points
MIC/LINE 1~24
Post GAIN and
A/D, Pre EQ
A/D, Pre EQ
Post EQ
Post Fader
TAPE 1~16, EFF1, EFF2
Pre EQ
Post EQ
Post Fader
BUS 1~8, AUX 1~8, STE-
REO OUT
REO OUT
Pre Fader
Post Fader
Setting the Bus Levels
1.
Use the CURSOR buttons
to select one of the bus
fader icons.
to select one of the bus
fader icons.
2.
Adjust the level of the
bus by rotating the
encoder wheel.
bus by rotating the
encoder wheel.