Yamaha PM5D-RH V2 Manual Do Utilizador
OUTPUT VIEW function
274
PM5D/PM5D-RH V2 / DSP5D Owner’s Manual
Reference section
In this screen you can copy the desired parameter(s) from
the selected output channel into a memory buffer, and
paste the same type of channel (you may select more than
one paste-destination).
the selected output channel into a memory buffer, and
paste the same type of channel (you may select more than
one paste-destination).
A JOB SELECT
• COPY
The copy-source channel will remain; its parameters
will be copied to another channel.
will be copied to another channel.
Note
You cannot turn off the COPY button.
B CAPTURE
When you click this button, the settings of the cur-
rently selected channel will be copied to a temporary
memory buffer.
If the corresponding MIX/MATRIX channel is paired
(or if a STEREO A/B channel is selected), a heart sym-
bol is displayed at the right.
rently selected channel will be copied to a temporary
memory buffer.
If the corresponding MIX/MATRIX channel is paired
(or if a STEREO A/B channel is selected), a heart sym-
bol is displayed at the right.
C BUFFERED CH (Channel in the buffer)
This shows the channel that is currently copied into
buffer memory.
buffer memory.
Note
• The same buffer memory is used to copy channel settings
for both input channels and output channels.
• If input channel settings have been copied to the buffer
memory, a message of “TYPE CONFLICT!” is displayed
below, and you cannot paste to an output channel.
below, and you cannot paste to an output channel.
• The contents of the buffer memory are erased when the
PM5D is powered-off.
D EXECUTE
When you click this button, the specified parameters
will be copied from buffer memory to the specified
paste-destination channel.
If an input channel is copied to buffer memory, or if no
paste-destination has been specified, this is grayed-out
and the Paste operation is unavailable.
will be copied from buffer memory to the specified
paste-destination channel.
If an input channel is copied to buffer memory, or if no
paste-destination has been specified, this is grayed-out
and the Paste operation is unavailable.
E PARAMETER SELECT
Here you can select the parameter(s) that will be
pasted. You can select the following parameters.
pasted. You can select the following parameters.
If the TO MTRX button is on, you can use the
MATRIX buttons (1–8) to select the applicable
MATRIX buses.
MATRIX buttons (1–8) to select the applicable
MATRIX buses.
CH JOB (Channel job) screen
CH JOB
1
3
2
ALL
All parameters
EQ
EQ function settings
COMP
COMP function settings
DELAY
DELAY function settings
FADER
Fader level
ON
CH [ON] key on/off status
BAL
Balance settings
INSERT
Insert on/off status and insert point
TO MTRX
Send level to the desired MATRIX bus(es)
DCA
Associated DCA group
MUTE
Associated mute group
LCR
LCR screen settings
WITHOUT
MIX SEND/
WITH MIX
SEND
MIX SEND/
WITH MIX
SEND
Selects whether the send level sent from
input channels to the selected MIX bus will
be included (WITH...) or will not be included
(WITHOUT...) in the pasted data.
input channels to the selected MIX bus will
be included (WITH...) or will not be included
(WITHOUT...) in the pasted data.
6
5
4
7
8
8