Yamaha PM5D-RH V2 Manual Do Utilizador

Here you can perform realtime control of surround pan-
ning for the two currently selected input channels.

A Channel selection

Select the two adjacent odd-numbered/even-num-
bered input channels (or ST IN channel L/R) that you 
want to control. The names of these channels are dis-
played at the right.

B DIVERGENCE

These controls specify the proportion at which the sig-
nals are sent to each surround bus when the input 
channel is positioned in the center. Depending on the 
currently selected surround mode, the displayed 
parameters will differ as follows.

❏ If Surround Mode = 3-1ch/5.1ch

A knob for controlling the front 
divergence is displayed. Use this 
knob to specify the proportion (0–
100) at which a signal positioned 
in the center will be sent to the 
center bus (C) and the left/right 
buses (L, R). With a setting of 0 
the signal will be sent only to the 
left/right buses, and with a setting 
of 100 it will be sent only to the center bus. With a set-
ting of 50, the signal will be sent at the same level to the 
left/right and center buses.

❏ If Surround Mode = 6.1ch

An F knob for controlling the front divergence and an 
R knob for controlling the rear divergence are dis-
played. Use these two knobs to specify the proportion 
(0–100) at which a signal positioned in the center will 
be sent to the center buses (C, S, Bs) and the left/right 
buses (L, R, Ls, Rs).
In 6.1ch mode, a LINK button 
that links the front and rear diver-
gence is displayed between the F 
knob and R knob. When you turn 
the LINK button on, the F knob 
value will be copied to the R knob, 
and the F knob and R knob values 
will be linked.

C LFE (Low Frequency Effect)

This adjusts the output level of the signal sent from the 
input channel to the LFE (Low Frequency Effect) bus 
for a subwoofer. You can use the ON/OFF button to 
switch the signal sent from the input channel to the 
LFE bus on/off.
The LFE knob and ON/OFF button are displayed only 
when the surround mode is 5.1ch or 6.1ch.

D Surround pan grid

This grid lets you control the surround panning, with 
the listening point at the center. The current setting is 
indicated by a O symbol.

E Position buttons

These buttons correspond to each surround bus. When 
you click a button, the surround panning will move to 
that position.

F SURROUND BUS ON/OFF buttons

These buttons are on/off switches for the signal sent 
from the input channel to the corresponding surround 
bus.

G Surround pan position

This indicates the coordinate locations of the O sym-
bol in the left/right direction and the front/rear 
direction.

1

2

3

4

5 6

7