Yamaha MGP12X Manual Do Utilizador
MGP16X/MGP12X Owner’s Manual
11
Setup
MGP12X
3.
Prepare the included rack-mount kit (2 sup-
ports and 6 screws).
ports and 6 screws).
4.
Use the included screws to fasten the rack-
mount supports with a triangular mark (
mount supports with a triangular mark (
) on
the top side, to the installed rack-mount brack-
ets in step 2.
ets in step 2.
Fasten them to the mixer in order (as shown): q center, w
front, and e back.
Similarly fasten the other side as well.
front, and e back.
Similarly fasten the other side as well.
CAUTION
Be sure to use the included screws with the MGP12X.
Using other screws can cause damage.
Using other screws can cause damage.
5.
Mount the unit into the rack, and fasten it into
place.
place.
Security Cover Mounting
In order to prevent the control knobs of the front panel from being
operated inadvertently, you can attach a protective cover using
four screw holes on the unit. (Size: M3; horizontal spacing:
410mm for MGP16X and 311mm for MGP12X; vertical spacing:
208.5mm.) Yamaha does not sell such a cover; however, you can
easily make one yourself and attach it to the front cover.
When mounting a cover make sure that the screws used do not go
deeper than 12 millimeters into the front panel. Also, to ensure
that the cover does not come in contact with the panel controls,
leave a space of about 20–25 millimeters between the front panel
and the cover.
operated inadvertently, you can attach a protective cover using
four screw holes on the unit. (Size: M3; horizontal spacing:
410mm for MGP16X and 311mm for MGP12X; vertical spacing:
208.5mm.) Yamaha does not sell such a cover; however, you can
easily make one yourself and attach it to the front cover.
When mounting a cover make sure that the screws used do not go
deeper than 12 millimeters into the front panel. Also, to ensure
that the cover does not come in contact with the panel controls,
leave a space of about 20–25 millimeters between the front panel
and the cover.
w
q
e
11U
13U