Roland S-1608 Manual Do Utilizador
6—Using the S-1608/S-0816 System
48
S-1608/S-0816 Digital Snake Owner’s Manual
fig.6-35.eps
Ordinarily, when plugging and unplugging devices to and from the
audio inputs and outputs on the S-1608 and S-0816 units, the volume
of all devices connected to the S-1608/S-0816 System’s audio outputs
should be lowered.
audio inputs and outputs on the S-1608 and S-0816 units, the volume
of all devices connected to the S-1608/S-0816 System’s audio outputs
should be lowered.
However, this may be impractical in some circumstances. In such cases,
you can temporarily mute the sound coming from the S-1608/S-0816
System’s audio outputs.
you can temporarily mute the sound coming from the S-1608/S-0816
System’s audio outputs.
1.
On the S-1608 or S-0816 front panel, press and hold the [MUTE ALL OUTPUTS] button. After
approximately 1.5 seconds, its indicator will light. No sound is output while the indicator is lit.
approximately 1.5 seconds, its indicator will light. No sound is output while the indicator is lit.
2.
When you have finished making input connections to the unit, release [MUTE ALL OUTPUTS].
Muting the System Outputs
The system outputs will become un-muted after releasing [MUTE ALL OUTPUTS]. If audio is passing
through the system when [MUTE ALL OUTPUTS] is released, the sound may be distorted until the
system outputs are completely un-muted.
through the system when [MUTE ALL OUTPUTS] is released, the sound may be distorted until the
system outputs are completely un-muted.
Note that [MUTE ALL OUTPUTS] only mutes the outputs of the S-4000 System, and not the outputs of
other devices. Before connecting the audio outputs on the S-1608 and S-0816 units to the audio
inputs of other devices, always turn down the volume or turn off the power on the receiving devices.
other devices. Before connecting the audio outputs on the S-1608 and S-0816 units to the audio
inputs of other devices, always turn down the volume or turn off the power on the receiving devices.
When an S-4000R is connected to the system, its CHANNEL display flashes when the audio outputs
are muted using [MUTE ALL OUTPUTS].
are muted using [MUTE ALL OUTPUTS].
If the REAC cable is disconnected while [MUTE ALL OUTPUTS] is held, it’s possible that one of the S-
1608/S-0816 units will remain in a muted state when [MUTE ALL OUTPUTS] is released. If this occurs,
use the following procedure:
1608/S-0816 units will remain in a muted state when [MUTE ALL OUTPUTS] is released. If this occurs,
use the following procedure:
1.
Reconnect the REAC cable.
2.
Press and release [MUTE ALL OUTPUTS].
Indicator
S-1608_e.book 48 ページ 2007年4月23日 月曜日 午後12時57分