Woodstock W1667 Manual Do Utilizador
-9-
To install the base and column, do these
steps:
1.
Position the drill press base on a flat and
stable surface.
stable surface.
2.
Using two clamps, clamp the base to the
mounting surface.
mounting surface.
3.
Use the holes provided in the bottom of
the base as a drill guide, and drill holes in
the mounting surface. See
the base as a drill guide, and drill holes in
the mounting surface. See
Figure 7.
4.
Secure the base using
5
⁄
16
" lag bolts or sup-
plied through bolts with washers and nuts.
5.
Place the column on the base, line up the
3 mounting holes, and secure tightly with
the three M8-1.25 x 16mm hex head bolts
using the open-end wrench provided.
3 mounting holes, and secure tightly with
the three M8-1.25 x 16mm hex head bolts
using the open-end wrench provided.
Figure 7. Using holes as a drill guide.
To install the dust port, do these steps:
1.
Position the two-piece dust port to the
bottom of the table. See
bottom of the table. See
Figure 8.
2.
Insert the four M4-0.7 x 22mm Phillips
head screws and tighten.
head screws and tighten.
Figure 8. Installing the dust port.
The dust port directs suction to the sanding
sleeve, removing hazardous dust and increasing
abrasive life.
sleeve, removing hazardous dust and increasing
abrasive life.
The base and column must be securely mount-
ed, so if drilling an odd-shaped workpiece the
machine will not fall over.
ed, so if drilling an odd-shaped workpiece the
machine will not fall over.
ASSEMBLY
Dust Port
Base and Column