Mitsubishi Electronics 60/60S Manual Do Utilizador

6.  Data In/Out 

6.4  PROGRAM COPY 

 

 

 

I-259 

 
 

The storage efficiency of the machining programs registered in memory may be lowered when correction 
such as data deletion or addition is made. When memory is used wastefully, the condense function can be 
used to move the intermediate blank portions forward and increase the remaining number of characters that 
can be registered. 

 

Set 2 in # (   ) for the condense command. To execute the condense function for all machining programs 
registered in memory, set ALL in first 0 (   ). 

 

Press the 

 

 

INPUT 

 key. 

To condense all work programs 
registered in memory 
# (2) 
O (ALL) 

→ O (      ) 

 
 
  # (2) O ( ALL)

→O(            ) 

 
  CONDENSE 

EXECUTIN 

  # (2) O ( ALL)

→O(            ) 

 
  CONDENSE 

COMPLETE 

  # ( ) O (        )

→O(            ) 

1)  Condense is started and the message 

"CONDENSE EXECUTION" is 
displayed in the message field.

 

2)  The time required for condense varies 

depending on the total number of the 
registered machining programs. Do 
not turn off the NC power during 
condense execution. 

 

 

1)  When using the 2-part system, the machining program condense operation can be switched with 

the parameters. 

0, 2, 4, 6 

- 

Of the machining programs registered in the memory common for the 
systems, the designated machining program is condensed. 

1, 3, 5, 7 

OFF 

Of the machining programs registered in the memory for the selected 
systems, the designated machining program is condensed. 

 

ON 

Of the machining programs registered in the memory for each system, the 
designated machining program is condensed. 

2)  When using the 2-part system and the same number batch generation for all system programs is 

valid, an error (E14) will occur if the all system condense program is not found. 

3)  When using the 2-part system and the same number batch generation for all system programs is 

valid, the programs cannot be condense in a system that does not have the condense program. 

4)  When using the 2-part system, and ALL is set, all machining programs registered in the memory 

for all systems will be condensed.